STR720 datasheet(300/401 Pages) STMICROELECTRONICS

300 / 401 page

STR720 - USB SLAVE INTERFACE (USB)

300/401

Reception Byte Count n (USB_COUNTn_RX)

This table location is used to store two different values, both required during packet reception.

The most significant bits contains the definition of allocated buffer size, to allow buffer overflow

detection, while the least significant part of this location is written back by the USB Peripheral

at the end of reception to give the actual number of received bytes. Due to the restrictions on

the number of available bits, buffer size is represented using the number of allocated memory

blocks, where block size can be selected to choose the trade-off between fine-granularity/

small-buffer and coarse-granularity/large-buffer. The size of allocated buffer is a part of the

endpoint descriptor and it is normally defined during the enumeration process according to its

maxPacketSize parameter value (See “Universal Serial Bus Specification”).

Address Offset: [USB_BTABLE] + n*16 + 12

USB local Address: [USB_BTABLE] + n*8 + 6

987654321

NUM_BLOCK[4:0]

COUNTn_RX[9:0]

Bit 15

BL_SIZE: BLock SIZE.

This bit selects the size of memory block used to define the allocated buffer

area.

•

If BL_SIZE=0, the memory block is 2 byte large, which is the minimum

block allowed in a word-wide memory. With this block size the allocated

buffer size ranges from 2 to 62 bytes.

•

If BL_SIZE=1, the memory block is 32 byte large, which allows to reach

the maximum packet length defined by USB specifications. With this

block size the allocated buffer size ranges from 32 to 1024 bytes, which

is the longest packet size allowed by USB standard specifications.

Bits 14:10

NUM_BLOCK[4:0]: Number of blocks.

These bits define the number of memory blocks allocated to this packet

buffer. The actual amount of allocated memory depends on the BL_SIZE

value as illustrated in Table 66.

Bits 9:0

COUNTn_RX[9:0]. These bits contain the number of bytes received by the

endpoint associated with the USB_EPnR register during the last OUT/

SETUP transaction addressed to it.

STR720 Datasheet(PDF) 300 Page - STMicroelectronics