HCS08 datasheet(158/198 Pages) NXP

158 / 198 page

Timer/Pulse-Width Modulator (S08TPMV2)

MC9S08QD4 Series MCU Data Sheet, Rev. 6

158

Freescale Semiconductor

11.5.3

Channel Event Interrupt Description

The meaning of channel interrupts depends on the current mode of the channel (input capture, output

compare, edge-aligned PWM, or center-aligned PWM).

When a channel is configured as an input capture channel, the ELSnB:ELSnA control bits select rising

edges, falling edges, any edge, or no edge (off) as the edge that triggers an input capture event. When the

selected edge is detected, the interrupt flag is set. The flag is cleared by the 2-step sequence described in

Section 11.5.1, “Clearing Timer Interrupt Flags.”

When a channel is configured as an output compare channel, the interrupt flag is set each time the main

timer counter matches the 16-bit value in the channel value register. The flag is cleared by the 2-step

sequence described in Section 11.5.1, “Clearing Timer Interrupt Flags.”

11.5.4

PWM End-of-Duty-Cycle Events

For channels that are configured for PWM operation, there are two possibilities:

•

When the channel is configured for edge-aligned PWM, the channel flag is set when the timer

counter matches the channel value register that marks the end of the active duty cycle period.

•

When the channel is configured for center-aligned PWM, the timer count matches the channel

value register twice during each PWM cycle. In this CPWM case, the channel flag is set at the start

and at the end of the active duty cycle, which are the times when the timer counter matches the

channel value register.

The flag is cleared by the 2-step sequence described in Section 11.5.1, “Clearing Timer Interrupt Flags.”

HCS08 Datasheet(PDF) 158 Page - NXP Semiconductors