STM32F413XG datasheet(147/207 Pages) STMICROELECTRONICS

No. de pieza	STM32F413XG

Descripción Electrónicos	ARM-Cortex-M4 32b MCUFPU, 125 DMIPS, up to 1.5MB Flash, 320KB RAM, USB OTG FS, 1 ADC, 2 DACs, 2 DFSDMs

PDF	207 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

147 / 207 page

DocID029162 Rev 2

147/207

STM32F413xG/H

Electrical characteristics

174

Note:

ADC accuracy vs. negative injection current: injecting a negative current on any analog

input pins should be avoided as this significantly reduces the accuracy of the conversion

being performed on another analog input. It is recommended to add a Schottky diode (pin to

ground) to analog pins which may potentially inject negative currents.

Any positive injection current within the limits specified for IINJ(PIN) and ΣIINJ(PIN) in

Section 6.3.16 does not affect the ADC accuracy.

Figure 48. ADC accuracy characteristics

1. See also Table 76.

2. Example of an actual transfer curve.

3. Ideal transfer curve.

4. End point correlation line.

5. ET = Total Unadjusted Error: maximum deviation between the actual and the ideal transfer curves.

EO = Offset Error: deviation between the first actual transition and the first ideal one.

EG = Gain Error: deviation between the last ideal transition and the last actual one.

ED = Differential Linearity Error: maximum deviation between actual steps and the ideal one.

EL = Integral Linearity Error: maximum deviation between any actual transition and the end point

correlation line.

STM32F413XG Datasheet(PDF) 147 Page - STMicroelectronics