TSOP775..W
AI

## Understanding the TSOP775..W Series
The **TSOP775..W** is a series of miniaturized infrared (IR) receiver modules designed for remote control systems. These parts integrate a photodiode, preamplifier, and control circuit into a single package, making them highly efficient for sensing IR signals.
### 1. Key Internal Components
The internal circuitry of the TSOP775..W consists of several stages to ensure signal integrity:
| Component | Function |
| :--- | :--- |
| **Photodetector** | Converts incoming IR light pulses into electrical current. |
| **Preamplifier** | Boosts the weak electrical signal from the photodiode. |
| **Automatic Gain Control (AGC)** | Adjusts sensitivity to compensate for ambient light interference. |
| **Band Pass Filter** | Filters out frequencies outside the specific carrier frequency (e.g., 38kHz). |
| **Demodulator** | Extracts the data signal from the carrier wave and outputs it as digital pulses. |
---
### 2. Technical Specifications
The "W" suffix usually denotes a wide-angle or specific package enhancement. Below are the typical electrical characteristics for this series:
| Parameter | Value/Range |
| :--- | :--- |
| **Supply Voltage ($V_S$)** | 2.5 V to 5.5 V |
| **Supply Current ($I_S$)** | 0.35 mA (typical) |
| **Carrier Frequency ($f_0$)** | 30 kHz to 56 kHz (model dependent) |
| **Transmission Distance** | Up to 45 meters |
| **Output Type** | Active Low (normally high, pulls to GND when signal detected) |
---
### 3. Pin Configuration
The TSOP775..W usually features a 3-pin lead frame. The standard pinout is as follows:
1. **OUT:** Data output (connects to a microcontroller GPIO).
2. **GND:** Ground connection.
3. **$V_S$:** Power supply.
---
### 4. Application Circuit
To ensure the best performance and noise immunity, a simple RC filter is recommended on the supply line.
```c
// Typical Connection Diagram
// [TSOP775 Pin] -------- [Microcontroller]
// 1. OUT ----------------> Digital Input
// 2. GND ----------------> Ground
// 3. Vs ----[ 100 Ohm ]--+--> 3.3V / 5V
// |
// [ 4.7uF Cap ]
// |
// Ground
```
### 5. Features of the "W" Version
* **Wide Viewing Angle:** Optimized for receiving signals from various angles (often ±45°).
* **High Immunity:** Excellent resistance against optical noise (fluorescent lamps, LCD backlights).
* **Low Power:** Ideal for battery-operated devices due to extremely low current consumption.
---
- ⤷
What are the specific carrier frequency options available for the TSOP775 series?
- ⤷ How does the AGC4 version differ from the AGC2 version in this series?
- ⤷ What is the recommended maximum baud rate for data transmission with this receiver?