Features
• AEC-Q101 qualified
• 1200 V symmetrical blocking voltage
• High junction temperature: 150 °C
• High noise immunity, static dV/dt: 1000 V/μs
• Embed two TN6050HP-12 dies in series
• Module qualified according to AQG324 recommendation
• SMD with isolated top cooled tab
• 4000 V insulated tab-to-lead package
– UL recognized, File E81734
• Terminal pins opposite to cooling side
– Fully automatic PCB mounting to heat sink
• Large creepage distance to meet IEC 60664-1
– 250 VAC, material group 2, pollution degree 3
– 600 VAC, material group 2, pollution degree 2
• ECOPACK2 compliant component

Description
The STTN6050H-12M1Y achieves a 1200 V 60 A full controlled SCR bridge leg in
ACEPACK SMIT module, and it can control an AC current up to 85 ARMS when
connected to an AC line network. Thus, it allows to design a single or three-phase
AC DC rectifier bridge, a phase recombination branch of a totem pole PFC up to 75
A(AVE) output current, the AC phasing arm of a line inverter or even an back-to-back
SCR based AC switch for a heating controller or the by pass relay of an UPS.
With its top cooling pad opposite to the printed circuit board this device allows the
PCB-module-heat sink stack to be automatically assembled. This provides a low
profile and compact converter in the field of on-board charger, charging station, motor
drive, UPS and AC-DC power supplies.
Based on the ST high temperature automotive ASD technology, it offers higher
specified noise immunity of 1000 V/μs at the 150 °C junction temperature Tj, and
an over-voltage robustness VDSM up to 1400 V.

Applications
• Single and tri-phase controlled rectifier bridge
• AC phasing half bridge of a totem pole PFC
• On-board and stationary chargers
• AC DC converter for motor drive, UPS and SMPS
• Output full wave DC current up to 75 AAV
• AC Input converter current up to 85 ARMS
• Solid-state relay in heating control , by pass switch and motor starter