|
Features
ZYNQ Processor
650MHz dual-core Cortex-A9 processor
DDR3 memory controller with 8 DMA channels and 4 High Performance AXI3 Slave ports
High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
Programmable from JTAG, Quad-SPI flash, and microSD card
Programmable logic equivalent to Artix-7 FPGA
Memory
512MB DDR3 with 16-bit bus @ 525MHz (1050MT/s)
16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-48/64™ compatible identifier
microSD slot
Power
Powered from USB or any 7V-15V external power source
USB and Ethernet
Gigabit Ethernet PHY
USB-JTAG Programming circuitry
USB-UART bridge
USB OTG PHY (supports host only)
Audio and Video
HDMI sink port (input)
HDMI source port (output)
PWM driven mono audio output with 3.5mm jack
Switches, Push-buttons, and LEDs
4 push-buttons
2 slide switches
4 LEDs
2 RGB LEDs
Expansion Connectors
Two Pmod ports
16 Total FPGA I/O
Arduino/chipKIT Shield connector
Up to 49 Total FPGA I/O (see table below)
6 Single-ended 0-3.3V Analog inputs to XADC
4 Differential 0-1.0V Analog inputs to XADC
|