|
Overview
The JTAG-HS3 programming cable is a high-speed programming/debugging solution for Xilinx FPGAs and SoCs. It is
fully compatible will all Xilinx Tools, and can be seamlessly driven from iMPACT, ChipScope™, EDK, and Vivado™.
The HS3 attaches to target boards using Xilinx’s 2x7, 2mm programming header.
The PC powers the JTAG-HS3 through the USB port and will recognize it as a Digilent programming cable when
connected, even if the cable is not attached to the target board. The HS3 has a separate Vref pin to supply the
JTAG signal buffers. The high speed 24mA three-state buffers allow the HS3 to drive target boards with signal
voltages from 1.8V to 5V and bus speeds up to 30MBit/sec (see Fig. 1). To function correctly, the HS3’s Vref pin
must be tied to the same voltage supply (VCCO_0) that drives the JTAG port on the FPGA.
Features include:
Small, complete, all-in-one JTAG
programming/debugging solution for Xilinx FPGAs and
SoCs
Plugs directly into standard Xilinx JTAG header
Separate Vref drives JTAG signal voltages; Vref can be
any voltage between 1.8V and 5V
High-Speed USB2 port that can drive JTAG bus up to
30Mbit/sec (frequency adjustable by user)
Compatible with Xilinx ISE® 14.1 and newer, Xilinx
Vivado 2013.3 and newer
Uses micro_AB USB2 connector
Open drain buffer on pin 14 allows debugging software
to reset the processor core of Xilinx’s Zynq® platform
|