NFMW488ART datasheet(39/40 Pages) NICHIA

39 / 40 page

NICHIA STS-DA1-4533B <Cat.No.170830>

(6) Thermal Management

● Proper thermal management is an important when designing products with LEDs. LED die temperature is affected by PCB thermal

resistance and LED spacing on the board. Please design products in a way that the LED die temperature does not exceed the

maximum Junction Temperature (TJ).

● Drive current should be determined for the surrounding ambient temperature (TA) to dissipate the heat from the product.

● The following equations can be used to calculate the LED temperature (i.e. TJ) once the saturation temperature at the junction has

been reached.

1) TJ=TA+RθJA･W

2) TJ=TS+RθJS･W

*TJ=LED junction temperature: °C

TA=Ambient temperature: °C

TS=Soldering temperature (cathode side): °C

RθJA=Thermal resistance from junction to ambient: °C/W

RθJS=Thermal resistance from junction to TS measurement point: °C/W

W=Input power(IF×VF): W

TS Measurement Point

(7) Cleaning

● The LEDs should not be cleaned with water, benzine, and/or thinner.

● If required, isopropyl alcohol (IPA) should be used. Other solvents may cause premature failure to the LEDs due to the damage

to the resin portion. The effects of such solvents should be verified prior to use. In addition, the use of CFCs such as Freon is

heavily regulated.

● When dust and/or dirt adheres to the LEDs, soak a cloth with Isopropyl alcohol (IPA), then squeeze it before wiping the LEDs.

● Ultrasonic cleaning is not recommended since it may have adverse effects on the LEDs depending on the ultrasonic power and how

LED is assembled. If ultrasonic cleaning must be used, the customer is advised to make sure the LEDs will not be damaged prior

to cleaning.

(8) Eye Safety

● In 2006, the International Electrical Commission (IEC) published IEC 62471:2006 Photobiological safety of lamps and lamp

systems, which added LEDs in its scope. On the other hand, the IEC 60825-1:2007 laser safety standard removed LEDs from its

scope. However, please be advised that some countries and regions have adopted standards based on the IEC laser safety

standard IEC 60825-1:20112001, which still includes LEDs in its scope. Most of Nichia's LEDs can be classified as belonging into

either the Exempt Group or Risk Group 1. High-power LEDs, that emit light containing blue wavelengths, may be classified as Risk

Group 2. Please proceed with caution when viewing directly any LEDs driven at high current, or viewing LEDs with optical

instruments which may greatly increase the damages to your eyes.

● Viewing a flashing light may cause eye discomfort. When incorporating the LED into your product, please be careful to avoid

adverse effects on the human body caused by light stimulation.

NFMW488ART Datasheet(PDF) 39 Page - NICHIA CORPORATION