MP7616

4

Rev. 2.00

ELECTRICAL CHARACTERISTICS (CONT’D)

NOTES:

Specifications are subject to change without notice

1

Full Scale Range (FSR) is 10V for unipolar mode.

2

Guaranteed but not production tested.

3

Digital input levels should not go below ground or exceed the positive supply voltage, otherwise damage may occur.

4

Specified values guarantee functionality. Refer to other parameters for accuracy.

5

Linearity error is degraded by 65

µV for every mV of voltage offset at output amplifier.

6

0 to +17 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Digital Input Voltage to GND

. . . .

. . . . . . . . . . .

+25 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

+25 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage Temperature

–65

. . . . . . . . . . . . . . . . .

Lead Temperature (Soldering, 10 seconds)

+300

. . . . . .

Package Power Dissipation Rating to 75

CDIP, PDIP, SOIC

1000mW

. . . . . . . . . . . . . . . . . . . . . . . .

Derates above 75

13mW/

. . . . . . . . . . . . . . . . . . . . .

NOTES:

1

Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a

stress rating only and functional operation at or above this specification is not implied. Exposure to maximum rating

conditions for extended periods may affect device reliability.

2

Any input pin which can see a value outside the absolute maximum ratings should be protected by Schottky diode clamps

(HP5082-2835) from input pin to the supplies.

APPLICATION NOTES

Refer to Section 8 for Applications Information