STV8216 datasheet(31/97 Pages) STMICROELECTRONICS

31 / 97 page

31/97

STV82x6

I²C Bus

8I²C Bus

8.1

I²C Address and Protocol

The STV82x6 I²C interface works in Slave mode and is fully compliant with I²C standards in Fast

mode (maximum frequency of 400 kHz). Two pairs of I²C chip addresses are used to connect two

STV82x6 chips to the same I²C serial bus. The device address pairs are defined by the polarity of

the ADR pin and are listed in the following table:

Protocol Description

● Write Protocol

● Read Protocol

● W = Write address,

● R = Read address,

● A = Acknowledge,

● N=No acknowledge.

● Sub-address is the register address pointer; this value auto-increments for both write and read.

The STV82x6 cannot immediately reply to an I²C read request when addressing DSP registers

(addresses 40h and greater).The I²C interface holds the I²C Serial Clock (SCL) line low before each

data byte is read to compensate for the latency of the DSP response (64 µs in worst case). The

implemented I²C Pulling Down mode is compatible with a Continuous or Stopped SCL when held

low (restart at high level, if stopped) and operates between 24 kHz and 400 kHz. If SCL Pulling

Down mode is not supported by the Master I²C interface, the Pulling Down system can be de-

activated by setting the SCLPD_OFF bit in register RESET. In this case, two successive reads of

the same DSP register are required and only the second one is valid (first read is ‘don’t care’). This

special protocol is no longer compatible with the I²C sub-address auto-incrementation function in

Read mode.

8.2

STV82x6 Reset

All STV82x6 features are controlled via the I²C bus. However, the device is designed to power up

into a fully working default mode without having to be sent I²C bus data to set it up.

The STV82x6 can be "reset" in 2 ways:

1. By Software via the I²C bus: This clears all synchronous logic, except for the I²C bus registers.

2. By Hardware via the RESET pin: In addition to clearing all synchronous logic, the RESET input

(active low) resets all the I²C bus registers to the default values listed below.

Table 8: I²C Read/Write Addresses

ADR

Write address (hex) (W)

Read address (hex) (R)

LOW (connected to GND1)

80h

81h

HIGH (connected to VDD1)

A0h

A1h

Start

Sub-address

Data

....

Data

Stop

Start

Sub-address

Stop

Start

Data

....

Data

STV8216 Datasheet(PDF) 31 Page - STMicroelectronics

STV8216 Datasheet(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

Datasheet Descarga

Enlace URL