MAS6512 datasheet(19/32 Pages) MAS

19 / 32 page

DA6512.003

2 December, 2016

19 (32)

2-WIRE SERIAL DATA INTERFACE (I2C BUS)

Figure 4. I2C bus protocol definitions

Bus communication includes Acknowledge (A) and

not Acknowledge (N) messages. To send an

acknowledge the receiver device pulls the SDA low

for one SCL clock cycle. For not acknowledge (N)

the receiver device leaves the SDA high for one

SCL clock cycle in which case the master can then

generate either a Stop (P) bit to abort the transfer,

or a repeated Start (Sr) bit to start a new transfer.

Abbreviations:

A= Acknowledge by Receiver

N = Not Acknowledge by Receiver

S = Start

Sr = Repeated Start

P = Stop

= from Master (MCU) to Slave (MAS6512)

= from Slave (MAS6512) to Master (MCU)

Conversion Starting – Write Sequence

Conversion is started by writing configuration bits

into the Measurement control register (address

E2HEX). The write sequence is illustrated in Table

12.

Table 12. MAS6512 I2C bus write sequence of Measurement control register

Abbreviations:

AW = Device Write Address ECHEX (%1110 1100)

AR = Device Read Address EDHEX (%1110 1101)

MC = Meas. control register 62HEX (%0110 0010)

Ax = Conversion Result Registers’ Addresses; MSB

(x=M, 6AHEX %0110 1010), LSB (x=L, 6BHEX %0110

1011)

DC = Measurement Control Register Data

Dx = Conversion Result Register Data; MSB (x=M),

LSB (x=L)

Each serial bus operation, like write, starts with the

start (S) bit (see figure 4). After start (S) the

MAS6512 device address with write bit (AW, see

table 11) is sent followed by an Acknowledge (A).

After this the Measurement control register address

(see table 1) is sent and followed by an

Acknowledge (A). Next the Measurement control

followed by an Acknowledge (A). Finally the serial

bus operation is ended with stop (P) command (see

figure 4). A new A/D conversion starts right after

Measurement control register bits containing

SCO=1 are received.

A/D Conversion

After power on reset or external reset (XCLR) the

EOC output is high. After an A/D conversion is

started the EOC output is set low until the

conversion is finished and the EOC goes back high,

indicating that the conversion is done and data is

ready for reading. The EOC is set low only by

starting a new conversion. To save power the

internal oscillator runs only during conversion.

During an A/D conversion the input signal is

sampled

continuously

leading

output

conversion result that is a weighted average of the

samples taken.

MAS6512 Datasheet(PDF) 19 Page - Micro Analog systems

MAS6512 Datasheet(HTML) 19 Page - Micro Analog systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Datasheet Descarga

Enlace URL