LP2 datasheet(18/27 Pages) EATON

18 / 27 page

EATON www.eaton.com

Right Angle Mounting Bracket

Right angle terminals are offered on the A3 & LP3. Configurations are

defined in these dimensions: X = pin extension beyond the block base; Z

= length from block base to centerline of the terminal tip. Standard bends

consist of the X and Z dimensions shown in the chart. Specify by adding

the selected Bend Option Code to the terminal part number.

04 Terminal Bend Configurations

Bend Option Code

(minimum)

Available

w/insulator base

R36

0.02

0.22

R42

0.08

0.16

R46

0.12

R50

0.16

0.08

Dimensions in inches. To convert to millimeters, multiply by 25.4.

07 Terminal Bend Configurations

Bend Option Code

(minimum)

Available

w/insulator base

R36

0.02

0.49

Yes

R50

0.16

0.35

R66

0.32

0.19

Dimensions in inches. To convert to millimeters, multiply by 25.4.

Angle Brackets (A3 only)

Option AB

Angle brackets enable block to be fastened at right angles to normal

mount position. Bulk part number 2AB-J.

Mounting Plates

Options MP & MT

MP Metal inserts with 0.150” dia. hole accept #6 screw.

MT Metal inserts with tapped hole accept #6-32 screw.

Bulk part number 2MP-J, 2MT-J.

Retaining Clip

Options RC

Use on standoff tubes. Fit panels up to 0.125” thick. Two clips

for every five positions. Supplied unassembled. Bulk part number

H541-J.

A3 & LP3

Single RowTerminal Blocks

Mounting Options Inches (Millimeters)

LP2 Datasheet(PDF) 18 Page - Eaton All Rights Reserved.

LP2 Datasheet(HTML) 18 Page - Eaton All Rights Reserved.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Datasheet Descarga

Enlace URL