PI3USB14Q datasheet(3/9 Pages) PERICOM

3 / 9 page

PS8760

02/01/05

PI3USB14

Low Voltage, High Bandwidth, USB 2.0,

4:1 Mux/DeMux with Single Enable

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.

2. Typical values are at VCC = 3.3V, +25°C ambient.

3. Per LVTTL driven input (control inputs only); Y and In pins do not contribute to ICC. This parameter is guaranteed, but not production tested.

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between Y and In pin at indicated current through the switch. On-Resistance is determined

by the lower of the voltages on the two (Y, In) pins.

5. This parameter is determined by device characterization but is not production tested.

Capacitance (TA = 25°C f = 1 MHz)

Parameters(5)

Description

Test Conditions

Typ.

Units

CIN

Input Capacitance

VIN = 0V

3.0

COFF(IN)

In Capacitance, Switch Off

3.5

COFF(Y)

Y Capacitance, Switch Off

CON

Y/In Capacitance, Switch On

15.0

Power Supply Characteristics

Parameters

Description

Test Conditions(1)

Min. Typ.(2) Max.

Units

ICC

Quiescent Power Supply Current

VCC = 3.6V, VIN = GND or VCC

0.8

PI3USB14Q Datasheet(PDF) 3 Page - Pericom Semiconductor Corporation

PI3USB14Q Datasheet(HTML) 3 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6 7 8 9

Datasheet Descarga

Enlace URL