LT1722CS5 datasheet(13/16 Pages) LINER

13 / 16 page

LT1722/LT1723/LT1724

172234fa

Power dissipation is composed of two parts. The first is

due to the quiescent supply current and the second is due

to on-chip dissipation caused by the load current.

Worst-case instantaneous power dissipation for a given

resistive load in one amplifier occurs at the maximum

supply current and when the output voltage is at half of

either supply voltage (or the maximum swing if less than

half supply voltage).

Therefore PD(MAX) in one amplifier is:

PD(MAX) =(V+ – V–)(IS(MAX)) + (V+/2)2/RL

PD(MAX) =(V+ – V–)(IS(MAX)) +

(V+ – VO(MAX))(VO(MAX)/RL)

Example. Worst-case conditions are: both op amps in the

LT1723IS8 are at TA = 85°C, VS = ±5V, RL = 150Ω,

VOUT = 2.5V.

PD(MAX) =2•[(10V)(5.95mA)+(2.5V)2/150Ω]=203mW

TJ(MAX) = 85°C + (203mW)(190°C/W) = 124°C

which is less than the absolute maximum rating at 150

°C.

APPLICATIO S I FOR ATIO

Circuit Operation

The LT1722/LT1723/LT1724 circuit topology is a voltage

feedback amplifier. The operation of the circuit can be

understood by referring to the Simplified Schematic. The

first stage is a folded cascode formed by the transistors

Q1 through Q4. A degeneration resistor, R, is used in the

input stage. The current mirror Q5, Q6 is bootstrapped by

Q7. The capacitor, C, assures the bandwidth and the slew

rate performance. The output stage is formed by comple-

mentary emitter followers, Q8 through Q11. The diodes

D1 and D2 protect against input reversed biasing. The

remaining part of the circuit assures optimum voltage and

current biases for all stages.

Low noise, reduced current supply, high speed and DC

accurate parameters are distinctive features of theLT1722/

LT1723/LT1724.

SI PLIFIED SCHE ATIC

+IN

–IN

Q10

–

OUT

1723 SS

Q11

VBIAS

LT1722CS5 Datasheet(PDF) 13 Page - Linear Technology

LT1722CS5 Datasheet(HTML) 13 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Descarga

Enlace URL