ST7LITE39 datasheet(60/167 Pages) STMICROELECTRONICS

60 / 167 page

ST7LITE3

60/167

DUAL 12-BIT AUTORELOAD TIMER 3 (Cont’d)

11.2.3.2 Output Compare Mode

To use this function, load a 12-bit value in the

Preload DCRxH and DCRxL registers.

When the 12-bit upcounter (CNTR1) reaches the

value stored in the Active DCRxH and DCRxL reg-

isters, the CMPFx bit in the PWMxCSR register is

set and an interrupt request is generated if the

CMPIE bit is set.

The output compare function is always performed

on CNTR1 in both Single Timer mode and Dual

Timer mode, and never on CNTR2. The difference

is that in Single Timer mode the counter 1 can be

compared with any of the four DCR registers, and

in Dual Timer mode, counter 1 is compared with

DCR0 or DCR1.

Notes:

1. The output compare function is only available

for DCRx values other than 0 (reset value).

2. Duty cycle registers are buffered internally. The

CPU writes in Preload Duty Cycle Registers and

these values are transferred in Active Duty Cycle

Registers after an overflow event if the corre-

sponding transfer bit (TRAN1 bit) is set. Output

compare is done by comparing these active DCRx

values with the counter.

Figure 40. Block Diagram of Output Compare Mode (single timer)

DCRx

OUTPUT COMPARE CIRCUIT

COUNTER 1

(ATCSR)

CMPIE

PRELOAD DUTY CYCLE REGx

ACTIVE DUTY CYCLE REGx

CNTR1

TRAN1

(ATCSR2)

OVF

(ATCSR)

CMPFx (PWMxCSR)

CMP

REQUEST

INTERRUPT

ST7LITE39 Datasheet(PDF) 60 Page - STMicroelectronics

ST7LITE39 Datasheet(HTML) 60 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL