| Motor de Búsqueda de Datasheet de Componentes Electrónicos |
|
TDA9381PS/N2 Datasheet(PDF) 40 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
TDA9381PS/N2 Datasheet(HTML) 40 Page - NXP Semiconductors |
|
40 / 118 page ![]() 2001 Jan 18 40 Philips Semiconductors Tentative Device Specification TV signal processor-Teletext decoder with embedded µ-Controller TDA935X/6X/8X PS/N2 series teletext decoder is error checked and stored in row 25, block 9 of the basic page memory. The device automatically detects whether teletext or VPS is being transmitted on this line and decodes the data appropriately. Each VPS byte in the memory consists of 4 bi-phase decoded data bits (bits 0-3), a bi-phase error flag (bit 4) and three 0s (bits5-7). The TXT13. VPS Received bit is set by the hardware whenever VPS data is acquired. The flag can be reset by writing a 0 into the SFR bit. WSS ACQUISITION The Wide Screen Signalling data transmitted on line 23 gives information on the aspect ratio and display position of the transmitted picture, the position of subtitles and on the camera/film mode. Some additional bits are reserved for future use. A total of 14 data bits are transmitted. All of the available data bits transmitted by the Wide Screen Signalling signal are captured and stored in SFRs WSS1, WSS2 and WSS3. The bits are stored as groups of related bits and an error flag is provided for each group to indicate when a transmission error has been detected in one or more of the bits in the group. Wide screen signalling data is only acquired when the TXT8.WSS ON bit is set. The TXT8.WSS RECEIVED bit is set by the hardware whenever wide screen signalling data is acquired. The flag can be reset by writing a 0 into the SFR bit. CLOSED CAPTION ACQUISITION The US Closed Caption data is transmitted on line 21 (525 line timings) and is used for Captioning information, Text information and Extended Data Services. Closed Caption data is only acquired when TXT21.CC ON bit is set. Two bytes of data are stored per field in SFRs, the first bye is stored in CCDAT1 and the second byte is stored in CCDAT2. The value in the CCDAT registers are reset to 00h at the start of the Closed Caption line defined by CCLIN.CS<4:0>. At the end of the Closed Caption line an interrupt is generated if IE.ECC is active. The processing of the Closed Caption data to convert into a displayable format is performed by Software. DISPLAY The display section is based on the requirements for a Level 1.5 WST Teletext and US Closed Caption. There are some enhancements for use with locally generated On-Screen Displays. The display section reads the contents of the Display memory and interprets the control/character codes. Using this information and other global settings, the display produces the required RGB signals and Video/Data (Fast Blanking) signal for the TV signal processing. The display is synchronised to the TV signal processing by way of Horizontal and Vertical sync signals generated within TDA935X/6x/8x. From these signals all display timings are derived. Display Features • Teletext and Enhanced OSD modes • Level 1.5 WST features • US Closed Caption Features • Serial and Parallel Display Attributes • Single/Double/Quadruple Width and Height for characters • Scrolling of display region. • Variable flash rate controlled by software. • Globally selectable scan lines per row 9/10/13/16. • Globally selectable character matrix (HxV) 12x9, 12x10, 12x13, 12x16. • Italics, Underline and Overline. • Soft Colours using CLUT with 4096 colour palette. • Fringing (Shadow) selectable from N-S-E-W direction. • Fringe colour selectable. • Meshing of defined area. • Contrast reduction of defined area. • Cursor. • Special Graphics characters with two planes, allowing four colours per character. • 32 Software re-definable On-Screen Display characters. • 4 WST Character sets(G0/G2) in single device (e.g. Latin,Cyrillic,Greek,Arabic). • G1 Mosaic graphics, Limited G3 Line drawing characters. • WST Character sets and Closed Caption Character set in single device. Display Modes The display section has two distinct modes with different features available in each. The two modes are: Fig.13 VPS Data Storage Teletext page header data VPS byte 11 VPS byte 12 VPS byte 13 VPS byte 14 VPS byte 15 VPS byte 4 VPS byte 5 0 9 10 11 121314 15 16 171819 20 21 22 23 column row 25 |
|
Enlace URL |
| ¿ALLDATASHEET es útil para Ud.? [ DONATE ] |
Todo acerca de Alldatasheet | Publicidad | Contáctenos | Política de Privacidad | Enlace a la hoja de datos | Intercambio de Enlaces | Lista de Fabricantes All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |