MODEL: R30PA2

R30PA2 SPECIFICATIONS

ES-9022 Rev.2 Page 1/5

https://www.m-system.co.jp/

Remote I/O R30 Series

TOTALIZED PULSE INPUT MODULE

(Pi 2 points, 32 Bits)

Functions & Features

• Space-saving remote I/O module of 2 points input pulse

counter

• 32-bit binary data

25 [.98]

mm [inch]

98

[3.86]

110

[4.33]

MODEL: R30PA2S[1]

ORDERING INFORMATION

• Code number: R30PA2S[1]

Specify a code from below for [1].

(e.g. R30PA2S/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

NO. OF CHANNELS

2: 2

COMMUNICATION MODE

S: Single

[1] OPTIONS

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-9022)

RELATED PRODUCTS

• Interface module

Model: R30NECT1 (firmware version V1.04.10 or higher)

Model: R30NCIE1 (firmware version V1.01.13 or higher)

• Paperless recorder

Model: TR30 (firmware version V1.05 or higher)

• PC configurator software (model: R30CFG)

Downloadable at M-System’s web site.

For connecting to PC, use commercially available Mini-B

type USB cable. (provided by user)

GENERAL SPECIFICATIONS

Connection

Internal bus: Via the Installation Base (model: R30BS)

Input: M3 separable screw terminal (torque 0.5 N·m)

Internal power: Via the Installation Base (model: R30BS)

Solderless terminal: Refer to the drawing at the end of the

section.

Recommended manufacturer: Japan Solderless Terminal

MFG. Co., Ltd., Nichifu Co., Ltd.

(Solderless terminals with insulation sleeve do not fit.)

Screw terminal: Nickel-plated steel

Isolation: Input or reset input or external power to internal

bus or internal power

Status indicator LEDs: RUN, ERR

Input status indicator LEDs: Green LED; turns on with input

ON

(Refer to the instruction manual.)

Count reset: by inputting one pulse to the reset input

terminal, or from host PC/PLC

Count preset: settable from host PC/PLC, or with PC

configurator software

■Recommended solderless terminal size - M3 (unit: mm)

12 max.

3 max.

3.2 dia.