MODEL: R3-PA16

R3-PA16 SPECIFICATIONS

ES-8389 Rev.12 Page 4/6

https://www.m-system.co.jp/

COUNTER SETTING FROM HOST PC/PLC

■ COUNTER RESET

(Available for R3-NC1, R3-NC3, R3-NE1, R3-NM1, R3-NDx, R3-NFL1, R3-NP1, R3-NML3 (Firmware version 2.00 or later))

Setting SW3-4 OFF and turning power on enable the function.

The bits indicating the channels to reset counter are allocated in the rst word from host PC/PLC.

When these bits are changed from 0 to 1, the counter is reset. When it is conrmed that the counter is reset, return to 0.

Notice that if the bit remains at 1, the next reset will not work.

0

15

Count reset CH.1

Count reset CH.16

Count reset CH.2

Count reset CH.3

Count reset CH.4

■ COUNTER PRESET

(Available in combination with R3-NE1, R3-NM1 (Firmware version 2.00 or later), and R3-PA16 displayed ‘SW3-4 RESET/PRESET’

on the right side)

Setting SW3-4 ON and turning power on enable the function.

Write the preset value to the Holding Resisters, which has same address as the Input Resisters.

• Input Resisters

• Holding Resisters

Address

n+0

n+1

n+2

n+3

n+14

n+15

Input 1

Input 2

Input 3

Address

n+0

n+1

n+2

n+3

n+14

n+15

Preset value of Input 1

Preset value of Input 2

Preset value of Input 3

Input 4

Input 15

Input 16

Preset value of Input 4

Preset value of Input 15

Preset value of Input 16