404 Westridge Dr. • Watsonville, CA 95076

831/761-6555 • 800/525-1609 • FAX 831/761-6544

www.appliedmotionproducts.com

STEPPER

SYSTEMS

59

POWER AMPLIFIER (MOTOR DRIVE):

AMPLIFIER TYPE .............................................. MOSFET, dual H-Bridge.

CURRENT CONTROL ......................................... 3 state, pulse width modulated, switching at 20–30 KHz.

OUTPUT CURRENT ........................................... 0.5–5.5 amps, software selectable.

POWER SUPPLY ............................................... Linear, toroidal transformer based for high reliability and low noise. 110

or 220 VAC input, switch selectable. 50/60 Hz.

DC BUS VOLTAGE ............................................. DC voltage at nominal line voltage: 75 VDC full load, 90 VDC no load.

AC INPUT VOLTAGE .......................................... 110 or 220 VAC (switch selectable) 50/60 Hz.

MAXIMUM OUTPUT POWER ............................ 440 watts.

IDLE CURRENT REDUCTION ............................ 0%, 25%, 50%, or 100% software selectable.

MOTOR RESOLUTION ....................................... 13 resolutions. Steps per revolution with 1.8

° motor: 2000, 5000,

10000, 12800, 18000, 20000, 21600, 25000, 25400, 25600, 36000,

50000, 50800, software selectable.

STATUS LED'S .................................................. AC power (red)

Over Temperature (yellow)

Over Current (yellow)

CONTROLLER (INDEXER) SECTION:

SERIAL COMMUNICATION ............................... RS-232 programming port.

INPUTS ............................................................. 8 user programmable inputs. Can be used for triggering, sensing, hom-

ing, branching, jogging or limits, optically isolated 5-24 VDC.

OUTPUTS .......................................................... 3 general purpose, optically isolated 12–24 VDC outputs for interfacing

to other equipment. Open collector and emitter. 100 mA max.

PARAMETER RANGES ...................................... Distance: 1 to 16,000,000 steps. Speed: .025 to 50 revolutions per sec-

ond (in any microstep resolution). Acceleration: 1 to 3,000 rev/sec/sec.

Deceleration: 1 to 3,000 rev/sec/sec (set independently from accelera-

tion). Time Delays: 0.01 to 300 seconds. Output Pulse Widths: 2 to 500

milliseconds. Iterations per repeat loop: 1 to 65,535.

OPTIONAL OPERATOR INTERFACE (MMI) ....... NEMA 4/12 rated (splash proof & dust proof). 4 x 20 characters liquid

crystal display (LCD)standard or backlit. 20 key membrane keypad. Over-

all size: 4.9 x 4.9 x 1.42 inches.

SYSTEM SPECIFICATIONS:

OVERALL SIZE .................................................. 3.0 x 5.3 x 8.0 inches.

CHASSIS MATERIAL ......................................... Aluminum, black anodized with integral heat sink.

WEIGHT ............................................................. 7.8 lbs.

AMBIENT TEMPERATURE ................................. 0˚ to 50˚C (32˚ to 122˚F).

HUMIDITY ......................................................... Maximum of 90% non-condensing.

CONNECTORS ................................................... Screw terminal connectors for input power and motor, and I/O signals.

MOTORS ........................................................... Can drive 4, 6 or 8 lead motors, NEMA sizes 11, 14, 17, 23 & 34.

CASE ................................................................. Steel with black paint and white epoxy silk screen. Includes switch covers.

AGENCY APPROVAL ......................................... CE & TUV.

Si5580 Technical Specifications