ICS94236 datasheet(14/17 Pages) ICST

14 / 17 page

ICS94236

0451A

—01/10/03

Fig. 1

Shared Pin Operation -

Input/Output Pins

The I/O pins designated by (input/output) on the ICS94236

serve as dual signal functions to the device. During initial

power-up, they act as input pins. The logic level (voltage)

that is present on these pins at this time is read and

stored into a 5-bit internal data latch. At the end of Power-

On reset, (see AC characteristics for timing values), the

device changes the mode of operations for these pins to

an output function. In this mode the pins produce the

specified buffered clocks to external loads.

To program (load) the internal configuration register for

these pins, a resistor is connected to either the VDD

(logic 1) power supply or the GND (logic 0) voltage

potential. A 10 Kilohm (10K) resistor is used to provide

both the solid CMOS programming voltage needed during

the power-up programming period and to provide an

insignificant load on the output clock during the subsequent

operating period.

Via to

VDD

Clock trace to load

Series Term. Res.

Programming

Header

Via to Gnd

Device

Pad

8.2K

Figure 1 shows a means of implementing this function

when a switch or 2 pin header is used. With no jumper is

installed the pin will be pulled high. With the jumper in

place the pin will be pulled low. If programmability is not

necessary, than only a single resistor is necessary. The

programming resistors should be located close to the

series termination resistor to minimize the current loop

area. It is more important to locate the series termination

resistor close to the driver than the programming resistor.

ICS94236 Datasheet(PDF) 14 Page - Integrated Circuit Systems

ICS94236 Datasheet(HTML) 14 Page - Integrated Circuit Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Datasheet Descarga

Enlace URL