EOSD - Occupancy Sensor Sub Desk

Installation Guide

Copyright EnOcean © 2020

Page 3 of 4

EOSD_Installation_Guide_V2.1

Linking is the process by which different devices are configured

to work with each other in a system. Sometimes this process is

also called Teach-in or Learn-in.

During Linking, the occupancy sensor has to communicate its

unique device address and the profile that it uses to the receiver

that will receive and react to telegrams from the sensor.

This information is available either from the device label (QR

code) or can be communicated via a dedicated telegram (a so-

called teach-in telegram).

To Link or Unlink an Occupancy Sensor

1. Set the desired receiver of the sensor telegram to Link or

Unlink mode (refer to the receiver device’s installation

guide).

2. Click the Menu button on the bottom of the sensor once.

This sends a link/unlink radio telegram.

NOTE: The button interface on the sensor is used for

linking and testing only. The occupancy timer settings

are configured on the transceiver to which the sensor is

linked.

Refer to the “Linking” section of the receiver installation

guide to complete the linking & setup process.

Use the walk test to confirm that motion is within the sensor’s

range.

NOTE: Before starting the test, ensure the battery is inserted for

5 minutes at least. If the sensor does not have a sufficient

power, it cannot enter into the test mode. No LED light or 1 red

blink when the set button is pressed indicates insufficient power.

1. Press and hold the Set button for 5 seconds.

••> Red LED will blink to confirm that a walk test is active.

2. Move in and out of the sensor‘s range to determine its

coverage area.

••> Sensor will blink when it detects motion.

3. Make small hand movements just inside the limit of the

sensor‘s range to see if the motion triggers a response.

4. The test mode will stay active for 3 minutes. To exit the test

before and resume normal operation, press and hold the

Menu button for 5 seconds.

NOTE: Ensure the sensor does not falsely trigger from user

activity outside the desired zone or other heat and motion

sources. If false triggering occurs, adjust the sensitivity

switch (next to the battery slot) from REG to LOW.

Linking

3

Walk Test

4