SLE datasheet(10/14 Pages) ITT

10 / 14 page

www.ittcannon.com

Dimensions shown in mm

Specifications and dimensions subject to change

Contact Extraction Tool

Part Number: 274-7068-001

Tip Part Number: 323-9519-000

· A Standard CET - SLE/SLC is available for

extraction of the individual crimp contacts. Insertion

tool is not required.

Snap-Lock Environmentally Sealed - Rectangular

Extraction Tool

Cannon SLE

Insertion/Extraction Instructions for Crimp Contacts

Insertion Tool

No insertion tool is required. The

contact is easily snapped in

from the rear of the connector

manually.

1. Move to the rear of the

connector so that the contact

cavities can be identified.

2. Insert a crimp terminated

assembly into a selected cavity.

3. Continue the forward movement

until and audible snap can be felt

and heard. Slight pull in the

opposite direction will confirm

complete insertion.

1. Open the CET - SLE Extraction

tool and place it over the insulation

of the wire.

2. Using a straight motion forward,

insert the tool along the wire until it

bottoms against the connector. (Do

not use a screwing motion -

damage will result.)

3. While the extraction tool is in

place, simply pull the wire/contact

assembly out.

4. Remove the extraction tool.

Extraction is complete.

Extraction

SLE Datasheet(PDF) 10 Page - ITT Industries

SLE Datasheet(HTML) 10 Page - ITT Industries

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Datasheet Descarga

Enlace URL