EV2000DJ-00A – LOW INPUT VOLTAGE, 150MA LINEAR REGULATOR EV BOARD

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV2000DJ-00A Rev. 1.0

www.MonolithicPower.com

3

9/26/2005

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2005 MPS. All Rights Reserved.

TM

PRINTED CIRCUIT BOARD LAYOUT

Figure 1—Top Silk Layer

Figure 2—Top Layer

QUICK START GUIDE

1. Attach the positive and negative ends of the load to the VOUT and GND pins, respectively.

respectively.

3. The default resistor values on the board are R1=28.7kΩ and R2=20kΩ. Changing these resistor

values will change the output voltage. Use the following equation to determine resistor values

for different output voltages:

⎟

⎠

⎞

⎜

⎝

⎛ +

×

=

2

R

1

R

1

V

5

.

0

T1 and T2 are test points for accurately measuring the input and output voltages.