INA163

SBOS177D

2

www.ti.com

V

O2

NC

GS2

V+

Ref

V

O

Sense

V

O1

NC

GS1

V

IN

−

V

IN+

V

−

NC

NC = No Internal Connection

14

13

12

11

10

9

8

1

2

3

4

5

6

7

PRODUCT

PACKAGE-LEAD

DESIGNATOR

MARKING

INA163UA

SO-14 Surface Mount

D

INA163UA

NOTE: (1) For the most current package and ordering information, see the Package Option Addendum located at the end of this document, or see the TI web site

at www.ti.com.

ELECTROSTATIC

DISCHARGE SENSITIVITY

This integrated circuit can be damaged by ESD. Texas

Instruments recommends that all integrated circuits be

handled with appropriate precautions. Failure to ob-

serve proper handling and installation procedures can

cause damage.

ESD damage can range from subtle performance deg-

radation to complete device failure. Precision integrated

circuits may be more susceptible to damage because

very small parametric changes could cause the device

not to meet its published specifications.

Power Supply Voltage .......................................................................

±18V

Signal Input Terminals, Voltage(2) .................. (V–) – 0.5V to (V+) + 0.5V

Current(2) .................................................... 10mA

Output Short-Circuit to Ground ............................................... Continuous

Operating Temperature .................................................. –55

°C to +125°C

Storage Temperature ..................................................... –55

°C to +125°C

Junction Temperature .................................................................... +150

°C

Lead Temperature (soldering, 10s) ............................................... +300

°C

NOTES: (1) Stresses above these ratings may cause permanent damage.

Exposure to absolute maximum conditions for extended periods may degrade

device reliability. These are stress ratings only, and functional operation of the

device at these or any other conditions beyond those specified is not implied.

(2) Input terminals are diode-clamped to the power-supply rails. Input signals

that can swing more than 0.5V beyond the supply rails should be current

limited to 10mA or less.

ABSOLUTE MAXIMUM RATINGS(1)

PACKAGE/ORDERING INFORMATION(1)

PIN CONFIGURATION

Top View