STM32L452VCU6 datasheet(45/210 Pages) STMICROELECTRONICS

45 / 210 page

DocID029968 Rev 3

45/210

STM32L452xx

Functional overview

3.23.1

Advanced-control timer (TIM1)

The advanced-control timer can each be seen as a three-phase PWM multiplexed on 6

channels. They have complementary PWM outputs with programmable inserted dead-

times. They can also be seen as complete general-purpose timers. The 4 independent

channels can be used for:

•

Input capture

•

Output compare

•

PWM generation (edge or center-aligned modes) with full modulation capability (0-

100%)

•

One-pulse mode output

In debug mode, the advanced-control timer counter can be frozen and the PWM outputs

disabled to turn off any power switches driven by these outputs.

Many features are shared with those of the general-purpose TIMx timers (described in

Section 3.23.2) using the same architecture, so the advanced-control timer can work

together with the TIMx timers via the Timer Link feature for synchronization or event

chaining.

3.23.2

General-purpose timers (TIM2, TIM3, TIM15, TIM16)

There are up to three synchronizable general-purpose timers embedded in the

STM32L452xx (see Table 11 for differences). Each general-purpose timer can be used to

generate PWM outputs, or act as a simple time base.

•

TIM2, TIM3

They are full-featured general-purpose timers:

–

TIM2 has a 32-bit auto-reload up/downcounter and 32-bit prescaler.

–

TIM3 has 16-bit auto-reload up/downcounter and 16-bit prescaler.

These timers feature 4 independent channels for input capture/output compare, PWM

or one-pulse mode output. They can work with the other general-purpose timers via the

Timer Link feature for synchronization or event chaining.

The counters can be frozen in debug mode.

All have independent DMA request generation and support quadrature encoder.

•

TIM15 and 16

They are general-purpose timers with mid-range features:

They have 16-bit auto-reload upcounters and 16-bit prescalers.

–

TIM15 has 2 channels and 1 complementary channel

–

TIM16 has 1 channel and 1 complementary channel

All channels can be used for input capture/output compare, PWM or one-pulse mode

output.

The timers can work together via the Timer Link feature for synchronization or event

chaining. The timers have independent DMA request generation.

The counters can be frozen in debug mode.

3.23.3

Basic timer (TIM6)

The basic timer is mainly used for DAC trigger generation. It can also be used as generic

16-bit timebase.

STM32L452VCU6 Datasheet(PDF) 45 Page - STMicroelectronics

STM32L452VCU6 Datasheet(HTML) 45 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL