VNH5200AS-E datasheet(7/31 Pages) STMICROELECTRONICS

No. de pieza	VNH5200AS-E

Descripción Electrónicos	Fully integrated H-bridge motor driver for automotive applications

PDF	31 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

7 / 31 page

DocID023424 Rev 9

7/31

VNH5200AS-E

Block diagram and pin description

Table 5. Pin functions description

Name

Description

VCC

Battery connection.

GND

Power ground.

OUTA

OUTB

Power connections to the motor.

INA

INB

Voltage controlled input pins with hysteresis, CMOS-compatible. These two pins

control the state of the bridge in normal operation according to the truth table (brake to

VCC, brake to GND, clockwise and counterclockwise).

ENA/DIAGA

ENB/DIAGB

Open drain bidirectional logic pins.These pins must be connected to an external pull

up resistor. When externally pulled low, they disable half-bridge A or B. In case of fault

detection (thermal shutdown of a high-side FET or excessive ON-state voltage drop

across a low-side FET), these pins are pulled low by the device (see Table 14: Truth

table in fault conditions (detected on OUTA)).

Analog current sense output. This output delivers a current proportional to the motor

current. The information can be read back as an analog voltage across an external

resistor.

VNH5200AS-E Datasheet(PDF) 7 Page - STMicroelectronics