Therefore, the complete slave address is:

1

0010

A1

A0

MSB

LSB

1.4 TEMPERATURE DATA FORMAT

Temperature data can be read from the Temperature and Set

Point registers; and written to the Set Point registers. Tem-

perature data can be read at any time, although reading

faster than the conversion time of the LM92 will prevent data

from being updated. Temperature data is represented by a

13-bit, two’s complement word with an LSB (Least Signifi-

cant Bit) equal to 0.0625 ˚C:

Temperature

Digital Output

Binary

Hex

+130˚C

0 1000 0 010 0000

08 20h

+125 ˚C

0 0111 1101 0000

07 D0h

+80 ˚C

0 0101 0000 0000

05 00h

+64 ˚C

0 0100 0000 0000

04 00h

+25 ˚C

0 0001 1001 0000

01 90h

+10 ˚C

0 0000 1010 0000

00 A0h

+2 ˚C

0 0000 0010 0000

00 20h

+0.0625 ˚C

0 0000 0000 0001

00 01h

0 ˚C

00 0000 0000

00 00h

Temperature

Digital Output

Binary

Hex

−0.0625 ˚C

1 1111 1111 1111

1F FFh

−25 ˚C

1 1110 0111 0000

1E 70h

−55 ˚C

1 1100 1001 0000

1C 90h

1.5 SHUTDOWN MODE

Shutdown mode is enabled by setting the shutdown bit in the

Configuration register via the Serial Bus. Shutdown mode

reduces power supply current to 5 µA typical. T_CRIT_A is

reset if previously set. Since conversions are stoped during

shutdown, T_CRIT_A and INT will not be operational. The

Serial Bus interface remains active. Activity on the clock and

data lines of the Serial Bus may slightly increase shutdown

mode quiescent current. Registers can be read from and

written to in shutdown mode. The LM92 takes miliseconds to

respond to the shutdown command.

1.6 INT AND T_CRIT_A OUTPUT

The INT and T_CRIT_A outputs are open-drain outputs and

do not have internal pull-ups. A "high" level will not be

10105106

Note: Event Interrupt mode is drawn as if the user is reading the part. If the user doesn’t read, the outputs would go low and stay that way until the LM92 is read.

Comparator Interrupt Mode is drawn as if the user never reads the part. If the user does read, the outputs will go high once read instruction is executed and, if the

fault condition still exists, go low at the end of the next conversion.

FIGURE 3. Temperature Response Diagram

www.national.com

9