5.3

Programming characteristics

Sensor ID

The sensor has an electrically stored ID which allows unique tracking after production.

 

Customer ID

Customer specific data, e.g. customer module ID, can be written in the EEPROM via SICI interface.

 

SICI programming SPC

The sensor can be programmed in a configuration of up to 4 bus participants on the same SPC bus line and the same

supply. The sensor output pin is tristate, if it was not addressed for communication.

5.3.1

Calibration and Look-Up-Table (LUT)

The sensor allows configuration of 32 equidistant calibration points or 16 freely programmable calibration points, as

shown at the below figures:

Input

LSB16

eep_mpc_lut_1

eep_mpc_lut_2

eep_mpc_lut_30

eep_mpc_lut_31

eep_mpc_lut_0

eep_mpc_lut_3

Figure 16

32 equidistant calibration points

TLE49SR

Datasheet

5  Specific module descriptions

Datasheet

29

Rev. 1.1.1

2024-03-13