7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DISCONNECTING THE AIR SUPPLY

Do not disconnect the air supply hose until the air supply has been shut down

and the compressed air released.

1. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

2. Once the pressure has been released, disconnect the air supply hose from

the air tool.

Store the tool safely in its box in a dry, secure environment.

MAINTENANCE

DAILY

1. Before use, drain water from the compressed air supply.

2. Pour a few drops of CLARKE airline oil, into the air inlet. This should be

carried out regardless of whether or not an in-line mini oiler is used. If an

inline mini oiler is not used, this procedure should be repeated after every

two to three hours of constant use.

CLEANING

1. Keep the body of the tool clean and free from debris. Grit or gum deposits

in the tool may reduce efficiency.

If the riveting action becomes erratic or the riveter operates but fails to form a

rivet successfully, it is possible that the jaw housing assembly (items 3 - 8) has

worked itself loose and requires adjusting. Should this occur, proceed as

follows:

1. Unscrew and remove the head assy (item 2).

2. Using the wrench supplied, hold the jaw housing coupler (item 7), undo the

locknut (item 8).

3. Place the 56mm gauge (on the edge of the wrench provided), alongside

the jaw housing assembly, and screw the jaw assy in or out, so that the lip

of the gauge is in line with the end face of the jaw housing (item 3.) Secure

in position with the locknut (item 8).

WARNING: MAKE SURE THAT THE TOOL IS DISCONNECTED FROM THE AIR

SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE

PROCEDURES.