| Motor de Búsqueda de Datasheet de Componentes Electrónicos |
|
DIO7911BAASC5 Datasheet(PDF) 8 Page - DIOO MICROCIRCUITS CO., LTD |
|
|
|||||||||||||||||||||||||||||
DIO7911BAASC5 Datasheet(HTML) 8 Page - DIOO MICROCIRCUITS CO., LTD |
|
8 / 13 page ![]() DIO7911 www.dioo.com © 2026 Dioo Microcircuits Co., Ltd. Jiangsu DIO7911• Rev.1.3 Adjustable output voltage The required output voltage of adjustable devices can be adjusted from VFB to 5 V by using two external resistors. Typical application schematics are shown in Figure 12. VOUT = VFB × (1 + R1/R2) Figure 12. Typical application It is recommended to keep the total serial resistance of resistors (R1 + R2) no greater than 50 kΩ. A good analog design practice is to connect a 1 nF connector from OUT to FB for better stability performance. Internal current limit The DIO7911 internal current limit helps to protect the regulator during fault conditions. During the current limit, the output sources a fixed amount of current that is largely independent of the output voltage. In such a case, the output voltage is not regulated and VOUT = ICL × RLOAD. The PMOS pass transistor dissipates (VIN – VOUT) × ICL until the thermal shutdown is triggered and the device turns off. As the device cools down, it is turned on by the internal thermal shutdown circuit. If the fault condition continues, the device cycles between the current limit and thermal shutdown. The PMOS pass element in the DIO7911 has a built-in body diode that conducts current when the voltage at OUT exceeds the voltage at IN. This current is not limited, so if extended reverse voltage operation is anticipated, external limiting to 5% of the rated output current is recommended. Shutdown The enable pin (EN) is active high. The device is enabled when the voltage at the EN pin goes above 0.8 V. The device is turned off when the EN pin is held at less than 0.3 V. When shutdown capability is not required, EN can be connected to the IN pin. Dropout voltage The DIO7911 uses a PMOS pass transistor to achieve low dropout. When (VIN – VOUT) is less than the dropout voltage (VDO), the PMOS pass device is in the linear region of operation and the input-to-output resistance is the RDS(on) of the PMOS pass element. VDO scales approximately with output current because the PMOS device behaves as a resistor in dropout. |
|
|
Enlace URL |
| ¿ALLDATASHEET es útil para Ud.? [ DONATE ] |
Todo acerca de Alldatasheet | Publicidad | Contáctenos | Política de Privacidad | Enlace a la hoja de datos | Intercambio de Enlaces | Lista de Fabricantes All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |