L6713ATR datasheet(10/64 Pages) STMICROELECTRONICS

10 / 64 page

Pin settings

L6713A

10/64

40 to

VID5 to

VID0

Intel mode. Voltage identification pins (also applies to VID6, VID7).

Internally pulled up by 25 µA to 5 V, connect to SGND to program a '0' or leave

floating to program a '1'.

They allow programming output voltage as specified in Table 7 and Table 8

according to VID_SEL status. OVP and UVP protection comes as a

consequence of the programmed code (See Table 12).

AMD mode. Voltage identification pins.

Internally pulled down by 12.5 µA, leave floating to program a '0' while pull up to

more than 1.4 V to program a '1'.

They allow programming the output voltage as specified in Table 10 (VID7

doesn’t care). OVP and UVP protection comes as a consequence of the

programmed code (See Table 12).

Note. VID6 not used, need to be shorted to SGND.

SS_END/

PGOOD

SSEND - Intel mode. soft-start end signal.

Open drain output sets free after SS has finished and pulled low when

triggering any protection. Pull up to a voltage lower than 5 V (typ), if not used it

can be left floating.

PGOOD - AMD mode.

Open drain output set free after SS has finished and pulled low when VSEN is

lower than the relative threshold. Pull up to a voltage lower than 5 V (typ), if not

used it can be left floating.

VR_HOT

Voltage regulator hot. Over temperature alarm signal.

Open drain output, set free when TM overcomes the alarm threshold.

Thermal monitoring output enabled if Vcc > UVLOVCC.

See “Thermal monitor” Section for details and typical connections.

VR_FAN

Voltage regulator fan. Over temperature warning signal.

Open drain output, set free when TM overcomes the warning threshold.

Thermal monitoring output enabled if Vcc > UVLOVCC.

See “Thermal monitor” Section for details and typical connections.

Thermal monitor input.

It senses the regulator temperature through apposite network and drives

VR_FAN and VR_HOT accordingly. Short TM pin to SGND if not used.

See “Thermal monitor” Section for details and typical connections.

SGND

All the internal references are referred to this pin. Connect to the PCB signal

Ground.

N.C.

Not internally connected.

N.C.

Not internally connected.

N.C.

Not internally connected.

PGND2

Channel 2 LS driver return path. Connect to power ground plane.

It must be connected to power ground plane also when using 2-phase

operation.

LGATE2

Channel 2 LS driver output. A small series resistor helps in reducing device-

dissipated power.

Leave floating when using 2 phase operation.

Table 2.

Pin description (continued)

N°

Function

L6713ATR Datasheet(PDF) 10 Page - STMicroelectronics

L6713ATR Datasheet(HTML) 10 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Descarga

Enlace URL