CS2000-CP

28

DS761PP1

8.2.3

Auxiliary Output Disable (AuxOutDis)

This bit controls the output driver for the AUX_OUT pin.

8.2.4

PLL Clock Output Disable (ClkOutDis)

This bit controls the output driver for the CLK_OUT pin.

8.3

Device Configuration 1 (Address 03h)

8.3.1

R-Mod Selection (RModSel[2:0])

Selects the R-Mod value, which is used as a factor in determining the PLL’s Fractional N.

8.3.2

Ratio Selection (RSel[1:0])

Selects one of the four stored User Defined Ratios for use in the static ratio based Frequency Synthesizer

Mode.

AuxOutDis

Output Driver State

0

AUX_OUT output driver enabled.

1

AUX_OUT output driver set to high-impedance.

Application:

“Auxiliary Output” on page 22

ClkOutDis

Output Driver State

0

CLK_OUT output driver enabled.

1

CLK_OUT output driver set to high-impedance.

Application:

“PLL Clock Output” on page 22

76543210

RModSel2

RModSel1

RModSel0

RSel1

RSel0

AuxOutSrc1

AuxOutSrc0

EnDevCfg1

RModSel[2:0]

R-Mod Selection

000

Left-shift R-value by 0 (x 1).

001

Left-shift R-value by 1 (x 2).

010

Left-shift R-value by 2 (x 4).

011

Left-shift R-value by 3 (x 8).

100

Right-shift R-value by 1 (÷ 2).

101

Right-shift R-value by 2 (÷ 4).

110

Right-shift R-value by 3 (÷ 8).

111

Right-shift R-value by 4 (÷ 16).

Application:

“Manual Ratio Modifier (R-Mod)” on page 18

RSel[1:0]

Ratio Selection

00

Ratio 0.

01

Ratio 1.

10

Ratio 2.

11

Ratio 3.

Application:

“User Defined Ratio (RUD), Frequency Synthesizer Mode” on page 17