TC14433AT-ESLASHOG datasheet(3/24 Pages) MICROCHIP

3 / 24 page

DS21394D-page 3

TC14433/A

1.0

ELECTRICAL

CHARACTERISTICS

Absolute Maximum Ratings†

Supply Voltage (VDD – VEE) ................... -0.5V to +18V

Voltage on Any Pin:

Reference to VEE .....................-0.5V to (VDD + 0.5)

DC Current, Any Pin: ....................................... ±10 mA

Power Dissipation (TA ≤ 70°C):

Plastic PLCC ................................................. 1.0W

Plastic PDIP.............................................. 940 mW

SOIC ......................................................... 940 mW

Operating Temperature Range ............ -40°C to +85°C

Storage Temperature Range .............. -65°C to +160°C

† Notice: Stresses above those listed under “Absolute

Maximum Ratings” may cause permanent damage to

the device. These are stress ratings only and functional

operation of the device at these or any other conditions

above those indicated in the operation sections of the

specifications is not implied. Exposure to Absolute

Maximum Rating conditions for extended periods may

affect device reliability.

TC14433/A ELECTRICAL SPECIFICATIONS

Electrical Characteristics: Unless otherwise specified, VDD = +5V, VEE = -5V, C1 = 0.1 µF, (Mylar), C0 = 0.1 µF,

RC = 300 kΩ, R1 = 470 kΩ @ VREF = 2V, R1 = 27 kΩ @ VREF = 200 mV, TA = +25°C.

Parameter

Symbol

Min

Typ

Max

Min

Typ

Max

Units

Test Conditions

Analog Input

Rollover Error (Positive) and

Negative Full Scale

Symmetry

SYE

-1

—

Counts

200 mV Full Scale

VIN -VIN = +VIN

Linearity Output Reading

(Note 1)

-0.05

+0.05

—

%rdg

VREF = 2V

-1 count

—

+1 count

—

%rdg

VREF = 200 mV

Stability Output Reading

(Note 2)

SOR

—

LSD

VX = 1.99V,

VREF = 2V

——

—

LSD

VX = 199 mV,

VREF = 200 mV

Zero Output Reading

ZOR

—

LSD

VX = 0V, VREF = 2V

Bias Current: Analog Input

Reference Input

Analog Ground

IIN

—

±20

±100

—

±20

±100

—

±20

±100

—

Common mode Rejection

CMRR

—

VX = 1.4V, VREF = 2V,

FOC = 32 kHz

Note

Accuracy – The accuracy of the meter at full scale is the accuracy of the setting of the reference voltage. Zero is

recalculated during each conversion cycle. The meaningful specification is linearity. In other words, the deviation from

correct reading for all inputs other than positive full scale and zero is defined as the linearity specification.

The LSD stability for 200 mV scale is defined as the range that the LSD will occupy 95% of the time.

Pin numbers refer to 24-pin PDIP.

TC14433AT-E/OG Datasheet(PDF) 3 Page - Microchip Technology

TC14433AT-E/OG Datasheet(HTML) 3 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Datasheet Descarga

Enlace URL