MFPROT_LP datasheet(9/35 Pages) RFSOLUTIONS

9 / 35 page

ib technology

Command Protocol

The following commands are supported. The corresponding acknowledge code should be read

back by the host and decoded to confirm that the command was received and handled

correctly. The serial bit protocol is 9600 baud, 8 bits, 1 stop, no parity (lsb transmitted first).

The status flags returned in the Acknowledge byte are as follows:

b7 b6 b5 b4 b3 b2 b1 b0

1 1 1 1

EEPROM error (Internal EEPROM write error)

| Card OK (Card serial number matched to identity code list)

| Rx OK (Card communication and acknowledgement OK)

RS232 error (Host serial communication error)

MF type (0 = MF 1k byte card, 1 = MF 4k byte card)

UL type (0 = MF standard 1k/4k card, SINGLE UID), 1 = MF Ultralight card, DOUBLE UID)

MFRC error (Internal or antenna fault)

Note that bit 7 is fixed so that using a Mifare 1k card, the RWD acknowledge response to a

valid host command would generally be 86 (Hex), indicating that a matched (or authorised)

MF 1k card is present. The MF Ultralight card has a different memory structure to the

standard 1k/4k MF cards so bits 4 and 5 have to be checked to determine which card type is

present. Note also that only the relevant flags are set after each command as indicated in the

following specification.

Card UID

Command to return card status and UID (Unique Identifier or Serial number).

The acknowledge byte flags indicate general Mifare card status.

Command:

0 1 0 1 0 1 0 1

(Ascii “U”, 0x55)

Acknowledge:

1 F F F F F F X

(F = Status flags)

Data only follows if card was selected OK with no errors detected.

Reply1:

D D D D D D D D

(D = LS Byte of UID/Serial number from card)

Reply2:

D D D D D D D D

Reply3:

D D D D D D D D

Reply4:

D D D D D D D D

Reply5:

D D D D D D D D

Reply6:

D D D D D D D D

Dummy bytes (0x00) for Mifare 1k/4k card types

Reply7:

D D D D D D D D

Note that Mifare 1k and 4k cards have a four-byte serial number but Mifare Ultralight cards

have a seven-byte serial number. To accommodate all card types, the Card UID command

returns a seven-byte field with the last three bytes padded out with 0x00 dummy bytes in the

case of Mifare 1k/4k cards.

MFPROT_LP Datasheet(PDF) 9 Page - rfsolutions.ltd

MFPROT_LP Datasheet(HTML) 9 Page - rfsolutions.ltd

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

Datasheet Descarga

Enlace URL