Application information

TS555

12/20

4

Application information

4.1

Monostable operation

In monostable mode, the timer operates like a one-shot generator. The external capacitor is

initially held discharged by a transistor inside the timer, as shown in Figure 4.

Figure 4.

Application schematic

triggered, the circuit remains in this state until the set time has elapsed, even if it is triggered

again during this interval. The duration of the output HIGH state is given by t = 1.1 R x C.

Since the charge rate and threshold level of the comparator are both directly proportional to

the supply voltage, the timing interval is independent of the supply. Applying a negative

pulse simultaneously to the Reset terminal (pin 4) and the Trigger terminal (pin 2) during the

timing cycle discharges the external capacitor and causes the cycle to start over. The timing

cycle then starts on the positive edge of the reset pulse. While the reset pulse is applied, the

output is driven to the LOW state.

When a negative trigger pulse is applied to pin 2, the flip-flop is set, releasing the short

circuit across the external capacitor and driving the output HIGH. The voltage across the

capacitor increases exponentially with the time constant

τ = R x C.

which then discharges the capacitor rapidly and drives the output to its LOW state. Figure 5

shows the actual waveforms generated in this mode of operation.

When Reset is not used, it should be tied high to avoid any false triggering.

Figure 5.

Timing diagram

Reset

Trigger

Out

3

2

4

8

7

6

5

1

TS555

R

C

Control Voltage

0.01 F

μ

CAPACITOR VOLTAGE = 2.0V/div

Ω

Ω

μ

t = 0.1 ms / div

INPUT = 2.0V/div

OUTPUT VOLTAGE = 5.0V/div

R = 9.1k , C = 0.01 F , R = 1.0k

L