PIC16F7X7 datasheet(7/276 Pages) MICROCHIP

7 / 276 page

 2004 Microchip Technology Inc.

DS30498C-page 5

PIC16F7X7

1.0

DEVICE OVERVIEW

This document contains device specific information

about the following devices:

PIC16F737/767 devices are available only in 28-pin

packages, while PIC16F747/777 devices are available

in 40-pin and 44-pin packages. All devices in the

PIC16F7X7 family share common architecture with the

following differences:

• The PIC16F737 and PIC16F767 have one-half of

the total on-chip memory of the PIC16F747 and

PIC16F777.

• The 28-pin devices have 3 I/O ports, while the

40/44-pin devices have 5.

• The 28-pin devices have 16 interrupts, while the

40/44-pin devices have 17.

• The 28-pin devices have 11 A/D input channels,

while the 40/44-pin devices have 14.

• The Parallel Slave Port is implemented only on

the 40/44-pin devices.

• Low-Power modes: RC_RUN allows the core and

peripherals to be clocked from the INTRC, while

SEC_RUN allows the core and peripherals to be

clocked from the low-power Timer1. Refer to

Section 4.7 “Power-Managed Modes” for

further details.

• Internal RC oscillator with eight selectable

frequencies, including 31.25 kHz, 125 kHz,

250kHz, 500kHz, 1MHz, 2 MHz, 4 MHz and

8 MHz. The INTRC can be configured as a primary

or secondary clock source. Refer to Section 4.5

“Internal Oscillator Block” for further details.

• The Timer1 module current consumption has

been greatly reduced from 20

µA (previous PIC16

devices) to 1.8

µA typical (32 kHz at 2V), which is

ideal for real-time clock applications. Refer to

Section 7.0 “Timer1 Module” for further details.

• Extended Watchdog Timer (WDT) that can have a

programmable period from 1 ms to 268s. The WDT

has its own 16-bit prescaler. Refer to Section 15.17

“Watchdog Timer (WDT)” for further details.

• Two-Speed Start-up: When the oscillator is

configured for LP, XT or HS, this feature will clock

the device from the INTRC while the oscillator is

warming up. This, in turn, will enable almost

immediate code execution. Refer to

Section 15.17.3 “Two-Speed Clock Start-up

Mode” for further details.

• Fail-Safe Clock Monitor: This feature will allow the

device to continue operation if the primary or

secondary clock source fails by switching over to

the INTRC.

The available features are summarized in Table 1-1.

Block

diagrams

the

PIC16F737/767

and

PIC16F747/777 devices are provided in Figure 1-1 and

Figure 1-2, respectively. The pinouts for these device

families are listed in Table 1-2 and Table 1-3.

Additional information may be found in the “PICmicro®

Mid-Range

MCU

Family

Reference

Manual”

(DS33023) which may be obtained from your local

Microchip Sales Representative or downloaded from

the Microchip web site. The Reference Manual should

be considered a complementary document to this data

sheet and is highly recommended reading for a better

understanding of the device architecture and operation

of the peripheral modules.

TABLE 1-1:

PIC16F7X7 DEVICE FEATURES

• PIC16F737

• PIC16F767

• PIC16F747

• PIC16F777

Key Features

PIC16F737

PIC16F747

PIC16F767

PIC16F777

Operating Frequency

DC – 20 MHz

Resets (and Delays)

POR, BOR

(PWRT, OST)

POR, BOR

(PWRT, OST)

POR, BOR

(PWRT, OST)

POR, BOR

(PWRT, OST)

Flash Program Memory (14-bit words)

Data Memory (bytes)

368

Interrupts

I/O Ports

Ports A, B, C

Ports A, B, C, D, E

Ports A, B, C

Ports A, B, C, D, E

Timers

Capture/Compare/PWM Modules

Master Serial Communications

MSSP, AUSART

Parallel Communications

—

PSP

—

PSP

10-bit Analog-to-Digital Module

11 Input Channels

14 Input Channels

11 Input Channels

14 Input Channels

Instruction Set

35 Instructions

Packaging

28-pin PDIP

28-pin SOIC

28-pin SSOP

28-pin QFN

40-pin PDIP

44-pin QFN

44-pin TQFP

28-pin PDIP

28-pin SOIC

28-pin SSOP

28-pin QFN

40-pin PDIP

44-pin QFN

44-pin TQFP

PIC16F7X7 Datasheet(PDF) 7 Page - Microchip Technology

PIC16F7X7 Datasheet(HTML) 7 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL