CS5180 datasheet(13/28 Pages) CIRRUS

13 / 28 page

CS5180

Instability Indicator

The MFLAG signal is functional in both modes of

operation of the part and indicates when the modu-

lator has been overdriven into an unstable condi-

tion. In the modulator only mode (MODE = 0), the

MFLAG signal will remain set for 3 MCLK cycles

when the modulator goes unstable, before being re-

turned to the reset state. While the input condition

causing modulator instability persists, the MFLAG

signal will continually get set for 3 MCLK cycles

and then get reset.

When the decimation filter on the part is operation-

al (MODE = 1), the MFLAG signal is set when the

modulator goes unstable. In this mode, however,

the MFLAG signal stays set until 5,120 MCLK cy-

cles after the input condition causing modulator in-

stability is removed.

This delay is provided to

allow the digital filter time to settle, and the part

will output fully settled conversion words after the

MFLAG signal goes low.

Digital Filter Characteristics

Figure 9 illustrates the magnitude versus frequency

plot of the converter when operating at 400 kHz

output word rate. The filter is a non-aliasing 4265

tap filter with a -3 dB corner at 0.4495 of the output

word rate and an out-of-band attenuation of at least

90 dB at frequencies above one half the output

word rate.

The passband ripple is less than

±0.05 dB up to the -3 dB corner frequency.

Figure 10 illustrates the phase response of the dig-

ital filter with the converter operating at 400 kHz

output word rate. The filter characteristics change

proportional to changes in the MCLK rate.

The group delay of the digital filter is 2,370 MCLK

cycles (92.6 µs with MCLK = 25.6 MHz), and the

settling time is 4,740 MCLK cycles (185.2 µs).

Serial Interface

The CS5180 has a serial interface through which

conversion words are output in a synchronous self-

clocking format. The serial port consists of the Se-

rial Data Output pin (SDO), and its complement

(SDO); Serial Clock (SCLK), and its complement

(SCLK); and the Frame Sync Output (FSO). FSO

falls at the beginning of an output word. Data is

output in twos complement format, MSB first.

FSO stays low for 16 SCLK cycles. SCLK is out-

put at a rate equal to MCLK/3.

Power Supplies / Board Layout

The CS5180 can be operated with VA+ supplies at

5 V and VD+ supplies at 5 V; or with VA+ at 5 V

and VD+ at 3 V.

Figure illustrates the system connection diagram

for the chip. For best performance, each of the

Figure 9. CS5180 Digital Filter Magnitude Response

(MCLK = 25.6 MHz)

Figure 10. CS5180 Digital Filter Phase Response

(MCLK = 25.6 MHz)

CS5180 Datasheet(PDF) 13 Page - Cirrus Logic

CS5180 Datasheet(HTML) 13 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Descarga

Enlace URL