24C04A-ESM datasheet(4/12 Pages) MICROCHIP

4 / 12 page

24C04A

DS11183E-page 4

2.0

FUNCTIONAL DESCRIPTION

The 24C04A supports a bidirectional two wire bus and

data transmission protocol. A device that sends data

onto the bus is deﬁned as transmitter, and a device

receiving data as receiver. The bus has to be con-

trolled by a master device which generates the serial

clock (SCL), controls the bus access, and generates

the START and STOP conditions, while the 24C04A

works as slave. Both master and slave can operate as

transmitter or receiver but the master device deter-

mines which mode is activated.

Up to four 24C04As can be connected to the bus,

selected by A1 and A2 chip address inputs. A0 must

be tied to VCC or VSS.

3.0

BUS CHARACTERISTICS

The following bus protocol has been deﬁned:

• Data transfer may be initiated only when the bus

is not busy.

• During data transfer, the data line must remain

stable whenever the clock line is HIGH. Changes

in the data line while the clock line is HIGH will be

interpreted as a START or STOP condition.

Accordingly, the following bus conditions have been

deﬁned (Figure 3-1).

3.1

Bus not Busy (A)

Both data and clock lines remain HIGH.

3.2

Start Data Transfer (B)

A HIGH to LOW transition of the SDA line while the

clock (SCL) is HIGH determines a START condition.

All commands must be preceded by a START condi-

tion.

3.3

Stop Data Transfer (C)

A LOW to HIGH transition of the SDA line while the

clock (SCL) is HIGH determines a STOP condition. All

operations must be ended with a STOP condition.

3.4

Data Valid (D)

The state of the data line represents valid data when,

after a START condition, the data line is stable for the

duration of the HIGH period of the clock signal.

The data on the line must be changed during the LOW

period of the clock signal. There is one clock pulse per

bit of data.

Each data transfer is initiated with a START condition

and terminated with a STOP condition. The number of

the data bytes transferred between the START and

STOP conditions is determined by the master device

and is theoretically unlimited.

3.5

Acknowledge

Each receiving device, when addressed, is obliged to

generate an acknowledge after the reception of each

byte. The master device must generate an extra clock

pulse which is associated with this acknowledge bit.

The device that acknowledges has to pull down the

SDA line during the acknowledge clock pulse in such a

way that the SDA line is stable LOW during the HIGH

period of the acknowledge related clock pulse.

course, setup and hold times must be taken into

account. A master must signal an end of data to the

slave by not generating an acknowledge bit on the last

byte that has been clocked out of the slave. In this

case, the slave must leave the data line HIGH to enable

the master to generate the STOP condition.

Note:

The 24C04A does not generate any

acknowledge bits if an internal program-

ming cycle is in progress.

FIGURE 3-1:

DATA TRANSFER SEQUENCE ON THE SERIAL BUS

SCL

SDA

(A)

(B)

(D)

(A)

(C)

START

CONDITION

ADDRESS OR

ACKNOWLEDGE

VALID

DATA

ALLOWED

TO CHANGE

STOP

CONDITION

24C04A-ESM Datasheet(PDF) 4 Page - Microchip Technology

24C04A-ESM Datasheet(HTML) 4 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Datasheet Descarga

Enlace URL