A6986 datasheet(43/67 Pages) STMICROELECTRONICS

No. de pieza	A6986

Descripción Electrónicos	38 V, 2 A synchronous step-down switching regulator with 30 µA quiescent current

PDF	67 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

43 / 67 page

DocID026211 Rev 6

43/67

A6986

Application notes

7.1

Output voltage adjustment

The error amplifier reference voltage is 0.85 V typical.

The output voltage is adjusted accordingly with Equation 41 (see Figure 29):

Equation 41

Cr1 capacitor is sometimes useful to increase the small signal phase margin (please refer to

Section 6.5: Compensation network design).

Figure 29. A6986 application circuit

7.2

Switching frequency

A resistor connected to the FSW pin features the selection of the switching frequency. The

pinstrapping is performed at power-up, before the soft-start takes place. The FSW pin is

pinstrapped and then driven floating in order to minimize the quiescent current from VIN.

Please refer toTable 6: fSW selection on page 11 to identify the pull-up / pull-down resistor

value. fSW = 250 kHz / fSW = 500 kHz preferred codifications don't require any external

resistor.

7.3

MLF pin

A resistor connected to the MLF pin features the selection of the between low noise mode /

low consumption mode and the different RST thresholds. The pinstrapping is performed at

power-up, before the soft-start takes place. The FSW pin is pinstrapped and then driven

floating in order to minimize the quiescent current from VIN.

VOUT

0.85

-------







A6986 Datasheet(PDF) 43 Page - STMicroelectronics