6

sUsage Precautions

1. Plugs

(1) Connection/

disconnection of

connectors

(2) Permissible load on

the cable after

connector mating.

(3) Precautions

1) To disconnect connectors, hook the end portion of U.FL-LP-N-2 and U.FL-LP(V)-N-2 onto the connector cover and

pull off vertically in the direction of the connector mating axis.

vertically in the direction of the connector mating axis.

(Please exercise caution so as not to injure fingertips or nails.)

2) To mate the connectors, the mating axes of both connectors are aligned

and the connectors are inserted as perpendicularly as possible.

Do not attempt to insert on an extreme angle.

After the connectors are mating, do not apply a load to the cable in excess of the values indicated in the diagram

below.

Do NOT forcefully twist or deform wires.

(1) Recommended

temperature profile

(Reference)

1) The temperature profile indicates the board surface temperature at the point of contacts with the connector

terminals (for surface mounted receptacle).

2) The temperature profile will change depending on conditions which include such factors as the size of the board,

the solder used, and the solder thickness.

(3) Recommended screen

thickness

0.1 to 0.15 mm

(2) Recommended

manual soldering

(Reference)

Manual soldering: 350˚C for 5 seconds

2. Receptacles

U.FL-LP-040

2N max.

2N max.

4N max.

U.FL-R-SMT

Time

Preheating

(130 to 165

℃)

Within 2 minutes

40 to 50

seconds

Heating peak

240

℃ 3 seconds

183

℃

260

240

220

200

180

160

140

120

100

80

(

℃)

Extraction Jig

U.FL-R-SMT

U.FL Cable

Assembly