PI5C3306LE datasheet(2/4 Pages) PERICOM

2 / 4 page

PS8857B

09/27/10

PI5C3306

2-Bit Bus Switch with Active Low Enables

Storage Temperature ......................................................... –65°C to +150°C

Ambient Temperature with Power Applied ........................ –40°C to +85°C

Supply Voltage to Ground Potential .................................... –0.5V to +4.6V

DC Input Voltage ................................................................. –0.5V to +5.5V

DC Output Current............................................................................ 120mA

Power Dissipation .................................................................................0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device.

This is a stress rating only and functional operation

of the device at these or any other conditions above

those indicated in the operational sections of this

specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may

affect reliability.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Notes:

1. This parameter is determined by device characterization but is not production tested.

Capacitance

Parameters(1)

Description

Test Conditions

Typ.

Units

CIN

Input Capacitance

VIN = 0V

COFF

A/B Capacitance, Switch Off

CON

A/B Capacitance, Switch On

DC Electrical Characteristics

Parameters

Description

Test Conditions(1)

Min. Typ.(2) Max. Units

VIH

Input HIGH Voltage

Guaranteed logic HIGH level

2.0

VIL

Input LOW Voltage

Guaranteed logic LOW level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

IOZ

High Impedance Output Current 0 ≤ A, B ≤ VCC

±1

Input Hysteresis at Control Pins

300

RON

Switch on Resistance (3)

VCC = 4.5V, VIN = 0.0V, ION = 30mA or 64mA

Ω

VCC = 4.5V, VIN = 2.4V, ION = 15mA

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined

by the lower of the voltages on the two (A,B) pins.

Power Supply Characteristics

Parameters

Description

Test Conditions(1)

Min.

Typ.(2)

Max.

Units

ICC

Quiescent Power Supply Current

VCC = Max.

VIN = GND or VCC

0.1

3.0

µA

∆ICC

Quiescent Current per Input HIGH

VIN = 3.4V(3)

2.5

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.

2. Typical values are at VCC = 5.0V, +25°C ambient.

3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to ICC.

(Over Operating Range, TA = –40°C to +85°C, VCC = 5.0V ±10%)

(TA = 25°C, f = 1 MHz)

10-0213

PI5C3306LE Datasheet(PDF) 2 Page - Pericom Semiconductor Corporation

PI5C3306LE Datasheet(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4

Datasheet Descarga

Enlace URL