CSC

www.vishay.com

Vishay Dale

Revision: 03-May-13

5

Document Number: 31509

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

CIRCUIT APPLICATIONS

01 Schematic

Bussed

The CSCxxx01 single-in-line resistor networks provide the user with

nominally equal resistors, each connected to a common pin (pin no. 1).

Commonly used in the following applications:

• “Wired OR” pull-up

• Open collector pull-up

• Power gate pull-up

• TTL input pull-down

• MOS/ROM pull-up/pull-down

• TTL unused gate pull-up

* “A” profile standard, “B” profile available.

03 Schematic

Isolated

The CSCxxx03 single-in-line resistor networks provide the user with

nominally equal resistors. Each resistor is isolated from all others.

Commonly used in the following applications:

• “Wired OR” pull-up

• Long-line impedance balancing

• Power driven pull-up

• LED current limiting

• Power gate pull-up

• ECL output pull-down

• Line termination

• TTL input pull-down

* “A” Profile standard, “B” profile available.

05 Schematic

Dual Terminator

The CSCxxx05 circuits contain series pairs of resistors. Each series

pair is connected between two common lines. The junction of these

resistor pairs is connected to the input terminals. The 05 circuits are

designed for TTL dual-line termination and pulse squaring.

* “A” profile standard, “B” profile available.

PERFORMANCE

TEST

CONDITIONS

MAX.

R (TYPICAL TEST LOTS)

Thermal shock

5 cycles between - 65 °C and + 125 °C

± 0.50 %

R

Short time overload

2.5 x rated working voltage, 5 s

± 0.25 %

R

Low temperature operation

45 min at full rated working voltage at - 65 °C

± 0.25 %

R

Moisture resistance

240 h with humidity ranging from 80 % RH to 98 % RH

± 1.00 %

R

Resistance to soldering heat

Leads immersed in + 350 °C solder to within 1/16" of body for 3 s

± 0.25 %

R

Shock

Total of 18 shocks at 100 g's

± 0.25 %

R

Vibration

12 h at maximum of 20 g's between 10 Hz and 2000 Hz

± 0.25 %

R

Load life

1000 h at + 70 °C, rated power applied 1.5 h “ON”, 0.5 h “OFF” for full

1000 h period. Derated according to the curve.

± 1.00 %

R

Terminal strength

4.5 pound pull for 30 s

± 0.25 %

R

Insulation resistance

10 000 M

 (minimum)

-

Dielectric withstanding voltage

-

1

2

3

n-1

n

1

2

3

4

n-1

n

1

2

3

n-1

n