L99MM70XP datasheet(18/68 Pages) STMICROELECTRONICS

No. de pieza	L99MM70XP

Descripción Electrónicos	INH input for external CAN transceiver

PDF	68 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

18 / 68 page

Description

L99MM70XP

18/68

Doc ID 022637 Rev 2

Figure 5.

Watchdog state diagram

3.7

Passive mode

L99MM70XP enters passive mode in case of:

●

Watchdog failure

●

VCC under voltage (NRES)

●

Thermal shutdown TSD2

●

SPI data in stuck at 0 or 1

In passive mode all control registers (except the reset level bit RSTLVL) and the

configuration register are set to default so that all outputs are switched off. The PASSIVE bit

inside the global status byte is set to “1”. The first valid SPI frame after entering the passive

mode resets the PASSIVE bit to “0” and leaves passive.

3.8

Reset output (NRES)

If VCC is turned on and the voltage exceeds the VCC reset threshold, the reset output NRES

is pulled up by internal pull up resistor to VCC voltage after a 2 ms reset delay time. This is

necessary for a defined start of the microcontroller when the application is switched on.

A low active reset pulse (2 ms) is generated in case of:

●

VCC drops below Vrth (configurable by SPI) for more than 8 µs (VCC under voltage)

●

Watchdog failure

L99MM70XP Datasheet(PDF) 18 Page - STMicroelectronics