CASR-6-NP datasheet(21/24 Pages) LEM

21 / 24 page

PCB footprint:

* = Pad design according

to IPC 2222, IPC 2221

Assembly on PCB

Recommended PCB hole diameter 1.3 mm for primary pin

0.8 mm for secondary pin

Maximum PCB thickness

2.4 mm

Wave soldering profile

maximum 260°C for 10 s

No clean process only.

Safety

This transducer must be used in electric/electronic equipment

with respect to applicable standards and safety requirements in

accordance with the manufacturer’s operating instructions

Caution, risk of electrical shock

When operating the transducer, certain parts of the module can

carry hazardous voltage (eg. primary busbar, power supply).

Ignoring this warning can lead to injury and/or cause serious damage.

This transducer is a built-in device, whose conducting parts must

be inaccessible after installation.

A protective housing or additional shield could be used.

Main supply must be able to be disconnected.

PCB footprints

Dimensions in mm. 1 mm = 0.034 inches

PCB footprint:

* = Pad design according

to IPC 2222, IPC 2221

PCB footprint:

* = Pad design according

to IPC 2222, IPC 2221

CAS Series

CASR Series

CKSR Series

CASR-6-NP Datasheet(PDF) 21 Page - LEM