T25S16AFEPR datasheet(56/74 Pages) HMSEMI

No. de pieza	T25S16AFEPR

Descripción Electrónicos	3V 128M-BIT SERIAL NOR FLASH WITH DUAL AND QUAD SPI&QPI

PDF	74 Pages

Scroll/Zoom	100%

Fabricante Electrónico	HMSEMI [Shenzhen Huazhimei Semiconductor Co., Ltd]

Página de inicio	http://www.hmsemi.com/

Logo

56 / 74 page

Figure 7.28 Release Power-down Instruction(SPI and QPI Mode)

Figure 7.29a Release Power-down / Device ID(SPI Mode)

Figure 7.29b Release Power-down / Device ID(QPI Mode)

7.5.3 Read Manufacturer / Device ID (90h)

The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down/Device

ID instruction that provides both the JEDEC assigned manufacturer ID and the specific device ID.

The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device ID

instruction. The instruction is initiated by driving the CS# pin low and shifting the instruction code “90h”

followed by a 24-bit address (A23-A0) of 000000h. After which, the Manufacturer ID and the Device ID are

shifted out on the falling edge of CLK with most significant bit (MSB) first as shown in Figure 7.30. If the 24-bit

address is initially set to 000001h the Device ID will be read first and then followed by the Manufacturer ID.

The Manufacturer and Device IDs can be read continuously, alternating from one to the other. The command

is completed by driving CS# high.

HM25Q128A

T25S16AFEPR Datasheet(PDF) 56 Page - Shenzhen Huazhimei Semiconductor Co., Ltd