WM8802SCFT datasheet(10/65 Pages) WOLFSON

No. de pieza	WM8802SCFT

Descripción Electrónicos	Digital Audio Interface Transceiver

PDF	65 Pages

Scroll/Zoom	100%

Fabricante Electrónico	WOLFSON [Wolfson Microelectronics plc]

Página de inicio	http://www.wolfsonmicro.com

Logo

10 / 65 page

WM8802

Product Preview

PP Rev 1.1 April 2004

DEVICE DESCRIPTION

INITIAL SYSTEM SETTINGS

SYSTEM RESET (XMODE)

The system operates normally when XMODE is set to High after applying a supply voltage of 3.0V or

greater. Following power ON, the system is reset by setting XMODE to Low again.

A 10k

Ω pull-down or pull-up resistor can be used to set EMPHA/UO, AUDIO /VO, CKST and

INT for the following:

•

chip address

•

demodulation function master or slave

•

modulation function or general-purpose I/O function settings

If EMPHA/UO, AUDIO /VO, CKST , and INT are not pulled up or down, their state is undefined. A

pull-up or pull-down resistor should always be connected to these pins.

SETTING

PINS

Chip address

EMPHA/UO, AUDIO /VO

Demodulation function master or slave

CKST

Modulation function or general-

purpose I/O function

INT

Table 1 Pin Names and Settings

Set pin state

XMODE

DVDD

Normal system operation range

Setting completed

Undefined

Setting input

state

Output state

Setting input

state

Output state

Min 200

µµµµs

3.0V

3.3V

Figure 3 Setting Timing Chart of Function Setting Input Pins

WM8802SCFT Datasheet(PDF) 10 Page - Wolfson Microelectronics plc

WM8802SCFT Datasheet(HTML) 10 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65

Datasheet Descarga

Enlace URL