Symbol

Parameter

Test Condition

Min.

Typ.

Max.

Unit

tDELAY,SC

VDS monitoring protection

delay time

See Figure 6

200

ns

Thermal protection(6)

TSD

Thermal shutdown

temperature

150

165

°C

TSDhys

Thermal shutdown

hystreresis

30

°C

1. These timings are measured using INHx/INLx mode (refer to Figure 4). An extra time is added when the device works with

ENx/INx mode (refer to Figure 2 and Figure 3)

2. MT = max. (|ton(GLS) - toff(GLS)|, |ton(GHS) - toff(GHS)|, |toff(GLS) - ton(GHS)|, |toff(GHS) - ton(GLS)|).

3. MTCH is the difference between the ton and toff of a channel and the same timings of any other channel.

4. MDT = | tDTHL - tDTLH | see Figure 2.

5. MDTCH is the difference between the t DTHL and t DTLH of a channel and the same timings of any other channel.

6. Based on characterization data on a limited number of samples, not tested during production

Figure 2. INx timings and deadtime (ENx/INx mode)

toff(1)

toff(1)

Note:

(1) this propagation delay is typically 16 ns longer than the one measured in INH/INL driving mode (testing condition).

Figure 3. ENx timings (ENx/INx mode)

EN

GHS

GLS

Note:

(1) this propagation delay is typically 16 ns longer than the one measured in INH/INL driving mode (testing condition).

toff(1)

ton(1)

toff(1)

tDT + ton(1)

IN

STDRIVE101

Electrical characteristics

DS13472 - Rev 1

page 9/32