ADRF5702BCCZN-R7 datasheet(24/27 Pages) AD

No. de pieza	ADRF5702BCCZN-R7

Descripción Electrónicos	Silicon Digital Attenuator, 0.125dB LSB, 8-Bit, 50MHz to 20GHz

PDF	27 Pages

Scroll/Zoom	100%

Fabricante Electrónico	AD [Analog Devices]

Página de inicio	http://www.analog.com

Logo

24 / 27 page

Data Sheet

ADRF5702

THEORY OF OPERATION

analog.com

Rev. A | 24 of 27

SERIAL OR PARALLEL MODE SELECTION

The ADRF5702 can be controlled in either serial or parallel mode

by setting the PS pin to high or low, respectively (see Table 9).

Table 9. Mode Selection

Control Mode

Low

Parallel

High

Serial

SERIAL MODE INTERFACE

The ADRF5702 supports a 4-wire serial peripheral interface (SPI):

serial data input (SERIN), clock (CLK), serial data output (SE-

ROUT), and latch enable (LE). The serial control interface is acti-

vated when the PS pin is set to high.

The ADRF5702 attenuation states can be controlled using the 8-bit

SERIN data.

In serial mode, the SERIN data is clocked MSB first on the rising

CLK edges into the shift register. Then, LE must be toggled high to

latch the new attenuation state into the device. LE must be set to

low to clock the new SERIN data into the shift register as CLK is

masked to prevent the attenuator value from changing if LE is kept

high. See Figure 53, Figure 54, the Timing Specifications section,

and the RF Input and Output section for additional information.

Figure 53. Serial Control Timing Diagram

Figure 54. Serial Output Timing Diagram

ADRF5702BCCZN-R7 Datasheet(PDF) 24 Page - Analog Devices