18

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

RESPIRATOR CARE & MAINTENANCE

The respirator must be used together with the correct particle filter at all times.

The particle filter can not be cleaned. Do not attempt to remove contamination using

for example, compressed air, as this will destroy the filters, which will not give the

expected protection and the warranty will be invalidated.

Do not store outside the temperature range -5'C to +55 'C or in relative humidity

greater than 90%. The filter must be kept clean from dust and large particles.

MARKINGS

The particle filters are marked according to EN12941:1998+Al:2003+A2:2008,

EU2016/425.

TH2P RSL: Class TH2, protection against Particulate, SL = particles of liquid or solid

material in aerosol form.

Filter type: HFR1000

FILTER REPLACEMENT

1. Blower body

2. HEPA Filter

3. Foam pre-filter

4. Cover

Attention: Filter screen and foam pre-filter

protects increases the life of the particle

filter HFS-1000.

CLEANING

Detach the battery pack, the breathing

tube and the blower. Inspect all parts for

damage and replace any damaged parts

prior to storage or next use.

a. Blower: Clean the outer surfaces of

PAPR assembly and battery pack with a

soft cloth dampened in a solution of

water and mild, pH neutral detergent. Do not immerse the blower or battery pack

in water. DO NOT use solvents or abrasive cleaners. DO NOT attempt to clean the

interior of the blower with compressed air or vacuum. Ensure the electrical

contacts of the blower and battery pack are dry.

b. Breathing tube: Clean the connection sites on the breathing tube with a water

and detergent solution. The breathing tube can be immersed in water for cleaning.

The inside of the tube must be completely dried prior to use or storage. Air dry, or