MPC8313ECVRAFDB datasheet(91/100 Pages) FREESCALE

91 / 100 page

MPC8313E PowerQUICC™ II Pro Processor Hardware Specifications, Rev. 2.1

Freescale Semiconductor

System Design Information

Figure 60. Driver Impedance Measurement

The value of this resistance and the strength of the driver’s current source can be found by making two

measurements. First, the output voltage is measured while driving logic 1 without an external differential

termination resistor. The measured voltage is V1 = Rsource × Isource. Second, the output voltage is measured

while driving logic 1 with an external precision differential termination resistor of value Rterm. The

measured voltage is V2 =(1/(1/R1 +1/R2)) × Isource. Solving for the output impedance gives Rsource =

Rterm × (V1/V2 – 1). The drive current is then Isource =V1/Rsource.

Table 72 summarizes the signal impedance targets. The driver impedance are targeted at minimum VDD,

nominal NVDD, 105°C.

22.7

Configuration Pin Muxing

The MPC8313E provides the user with power-on configuration options which can be set through the use

of external pull-up or pull-down resistors of 4.7 k

Ω on certain output pins (see customer visible

configuration pins). These pins are generally used as output only pins in normal operation.

While HRESET is asserted however, these pins are treated as inputs. The value presented on these pins

while HRESET is asserted, is latched when PORESET deasserts, at which time the input receiver is

disabled and the I/O circuit takes on its normal function. Careful board layout with stubless connections

to these pull-up/pull-down resistors coupled with the large value of the pull-up/pull-down resistor should

minimize the disruption of signal quality or speed for output pins thus configured.

Table 72. Impedance Characteristics

Impedance

Local Bus, Ethernet,

DUART, Control,

Configuration, Power

Management

PCI Signals

(Not Including PCI

Output Clocks)

PCI Output Clocks

(Including

PCI_SYNC_OUT)

DDR DRAM

Symbol

Unit

42 Target

25 Target

42 Target

20 Target

42 Target

25 Target

42 Target

20 Target

Differential

ZDIFF

Note: Nominal supply voltages. See Table 1, TJ = 105°C.

NVDD

VSS

Pad

Data

SW1

SW2

MPC8313ECVRAFDB Datasheet(PDF) 91 Page - Freescale Semiconductor, Inc

MPC8313ECVRAFDB Datasheet(HTML) 91 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100

Datasheet Descarga

Enlace URL